Termékek következő (4)

Unsere Kernkompetenz liegt in der Herstellung von Schmiedeteilen aus Stahl, Schmiedeteilen aus Edelstahl und Schmiedeteilen Aluminium in der Gewichtsklasse 0,1-6 kg.

Telefonanlagen für den All-IP Anschluß und ISDN-Ämter

In the injection moulding process TPE pellets are fed into the machine through a hopper and then into a heated barrel. The heat from the barrel turns the material into a liquid resin which is then injected into a closed mould under high pressure. After allowing the molten polymer to cool, the finished part can be removed from the mould. Injection moulding is a high-volume, high tooling cost process, the advanced properties of our TPE compounds deliver short cycle times allowing parts to be produced at a rapid rate. The information below is intended as a general overview, settings may vary depending on the specific grade selected. Please CONTACT US for detailed processing information Settings Equipment Conventional injection moulding machine Compression set At least 2:1. Special screws with short sections and higher compression ratios (3:1 to 4:1) may be good at low screw speeds Shrinkage Between 1.0% and 2.5% depending on the grade, type of application and location of the gate. Moul

Kolben sind entscheidende Komponenten in hydraulischen und pneumatischen Systemen. Unsere Kolben zeichnen sich durch exakte Fertigung und hohe Belastbarkeit aus, was eine effiziente und zuverlässige Leistung in verschiedensten Anwendungen gewährleistet.