Termékek tribo bevonat (2)

Bond Plus Adhesive latex based on elastomeric styrene-butadiene rubber and alkaline silicate in aqueous dispersion, flexibilising, reactive, for adhesive grout and to improve adhesion, the behaviour and performance of mortars and plasters. Production of adhesive, deformable, high-protective and waterproofing performance mortars and plasters for civil, hydraulic, industrial works, in urban, marine and mountain atmospheres. Preparation of hydrating solutions to improve the adhesion and performance of premixed mortars and plasters; preparation of adhesive grouts for non-structural construction joints. Anti-dust treatments, reinforcing concrete surfaces. Shake Bond Plus thoroughly in the tank, and dilute it with water as required. Add the prepared solution to the cement (or lime) and aggregates mixture, in the most suitable dosages for this application, as specified below. It is always essential to carry out preliminary tests for an accurate definition of the mixtures to use, and to check the suitability of the product on the basis of the specific requirements. Refer to the table shown in the product datasheet. Packaging: 25 kg can UM: €/kg

ECOFIX PLUS the best adhesive spray for printing boards ECOFIX PLUS is an high tack adhesive specially indicated for the textile silk-screen printing industry. It is suitable to keep the fabrics steady to their support while being printed. CHEMICAL BASE BASE: Synthetic rubbers and solid resins SOLVENTS: hydrocarbure group, benzen and omologous are absent PROPELLENT: Denaturate odourless hydrocarbure COLOUR: Yellow clear VISCOSITY: Middle IT DOES NOT CONTAINS CFC MAIN CHARACTERISTICS It does not transfer on the fabric or cloths printed. It does not dirty the fabrics. It is suitable for cotton, silk, wool, synthetic fabrics, cotton, mixed. It resists to many applications. It has a good resistance to heat. It is also suitable in embroidery industry to keep the cloth steady during embroidery. In the cut rooms it gets the adhesion of the model to the cloth during the cut. DIRECTIONS FOR USE Shake well the can before use. Spray the product from a distance of 25-30 cm. Remove it with wash solvent perchloroethylene.